Peugeot 308 Key Fob Replacement
Peugeot's 308 might be getting on a little however, it's still eye-catching. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable driving experience.
We are often asked at Coded Car Keys to replace peugeot key fobs. The following suggestions will aid in solving the issue whether it is persistent or intermittent.
Water Damage
If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking canoeing, rafting, or canyoning the fob is more likely to be damaged by water. The best way to prevent this from happening is to always keep it in a dry bag when you're outside or performing things where the fob might be exposed to excessive amounts of water.
You'll also need to make sure that the fob is dry before opening it up and reusing it. If you detect any odors emanating from the fob (such as industrial fluid or windshield washer fluid) It's another indicator that it is submerged.
A wet circuit board can cause the battery to discharge its energy or even explode. If you're able fish your key fob 308 out of the water body it got stuck in then flip the button side down and shake out as much water as you can before opening the case. After opening it, remove the battery and wipe down the circuit board using an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system might fail to function include a dead coin battery, receiver module issues signal interference, an electronic chip that is defective. If none of the above are the problem, you can try resetting your system by disconnecting the battery at 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start that lets drivers start their car from some distance, which allows them to warm up or cool down the car before entering. This feature is extremely useful particularly during the cold winter months. However, it is possible that the remote start system ceases operating due to a range of reasons, including an unresponsive coin battery.
A coin-shaped battery in the key fob can last for a period of two to four years, based on how often it's used and where it's purchased. Its use-by date is typically printed on the packaging or written in the manual.
If the key fob stops working after exposure to clean tap water, you should remove the battery, clean the chip using a paper towel and isopropyl alcohol, then dry it completely before replacing it. If the key fob was exposed to salty or soapy water, it could have caused the chip to be damaged. You'll need to replace it.
If you're unsure if the battery is faulty it is possible to test the voltage with a multimeter that is set to the car's voltage range and connected to the terminals for minus and plus. The voltage should read approximately 12-13 volts but if it is lower, the battery should be replaced. You can also reset the computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should start after this.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. It's the part that sends an indication to the car when the key fob is activated, which also acts as an immobiliser and prevents it from starting until the correct key is used.
This could result from a variety of causes, such as water damage or simply the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, for example, the electronic chip inside is damaged. In this situation, you'll have to take it off and thoroughly clean it using isopropyl or electronic cleaner. Once the battery has dried you can try it again.
If the issue persists the issue persists, it's a good idea to visit an area Peugeot specialist or locksmith. They can employ a diagnostic tool in order to identify the issue and fix it.
It can be stressful to lose your Peugeot car key. A qualified auto locksmith can resolve the issue within minutes. They can cut a new key and program it to your vehicle, so you're ready to get on the road again as quickly as possible. Click here to find a local locksmith near you.
Faulty electronic chip
The electronic chip that is in the Peugeot 308 key fob is a critical role in the remote control system. If it is damaged your car may not start or receive a message that reads "anti-theft active". In this case, the only solution is to replace the key. Auto locksmiths who are professionals are able to offer the service within the shortest possible time.
The chip inside your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or other reasons. If your Peugeot 308 key fob has been exposed to soapy water, clean it right away. You can employ a paper towel as well as isopropyl ethanol to clean the electronic component. peugeot partner van key should then be allowed to fully dry.
Radio interference can cause the key fob to cease working. This can be caused by other devices operating at the same frequency as your Peugeot key fob. This can be caused by unsafe conditions or objects that are in the vicinity of the vehicle. If you experience this problem it is advised to visit an Peugeot dealership.
The Peugeot key fob 207/308 is very delicate and requires special care. You should not drop it or throw it around. If you lose something, try to find it as soon as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Disconnect the negative cable before the positive.